Website navigation
 5-1
 Numerical control spring drawing machine

Numerical control spring drawing machine


Product overview

*Spring end detection:    
  The change of wire feeding value can be used to judge whether the outer diameter changes;    
*Groove ring detector:    
   After the hook ring is formed, the carrier shall check the total length of the tension spring before releasing the spring, and drive the unqualified into the defective side.    
*Cut off checker:    
    When it cannot be cut off, the machine will stop immediately.    
*Sorter: sorting good and bad products    

technical parameter
model CTS-210
Wire diameter range 0.1 - 1.0mm
external diameter 10mm
Spring length 100mm
Fastest production rate one hundred piece / minute
Matching rack


Online consultation